Si5351A Clock Generator Breakout Board - 8KHz to 160MHz
9,70 € 6,80 €
-30%
Iva inclusa
ADAFRUIT

Si5351A Clock Generator Breakout Board - 8KHz to 160MHz

ADAFRUIT
Si5351A Clock Generator Breakout Board - 8KHz to 160MHz
Si5351A Clock Generator Breakout Board - 8KHz to 160MHz
COD: 309141
COD.MEPA: 309141CS

Descrizione

Never hunt around for another crystal again, with the Si5351A clock generator breakout from Adafruit! This chip has a precision 25MHz crystal reference and internal PLL and dividers so it can generate just about any frequency, from <8KHz up to 150+ MHz.

The Si5351A clock generator is an I2C controller clock generator. It uses the onboard precision clock to drive multiple PLL's and clock dividers using I2C instructions. By setting up the PLL and dividers you can create precise and arbitrary frequencies. There are three independent outputs, and each one can have a different frequency. Outputs are 3Vpp, either through a breadboard-friendly header or, for RF work, an optional SMA connector.

We put this handy little chip onto it's own breakout board PCB, with a 3.3V LDO regulator so it can be powered from 3-5VDC. We also put level shifting circuitry on the I2C lines so you can use this chip safely with 3V or 5V logic.
9,70 € 6,80 €
-30%
Iva inclusa
Disponibile
Il prodotto è disponibile presso il nostro magazzino Disponibile:
Il prodotto è disponibile presso il nostro magazzino

Descrizione

Never hunt around for another crystal again, with the Si5351A clock generator breakout from Adafruit! This chip has a precision 25MHz crystal reference and internal PLL and dividers so it can generate just about any frequency, from <8KHz up to 150+ MHz.

The Si5351A clock generator is an I2C controller clock generator. It uses the onboard precision clock to drive multiple PLL's and clock dividers using I2C instructions. By setting up the PLL and dividers you can create precise and arbitrary frequencies. There are three independent outputs, and each one can have a different frequency. Outputs are 3Vpp, either through a breadboard-friendly header or, for RF work, an optional SMA connector.

We put this handy little chip onto it's own breakout board PCB, with a 3.3V LDO regulator so it can be powered from 3-5VDC. We also put level shifting circuitry on the I2C lines so you can use this chip safely with 3V or 5V logic.

Recensioni

Hai comprato questo prodotto? Fai sapere agli altri cosa ne pensi.
Valuta