
DFROBOT
Romeo V2-All in one Controller
Romeo V2-All in one Controller
COD: 304816
COD.MEPA: 304816CS
COD.MEPA: 304816CS
Descrizione
Wide operating input voltage
Directly support Xbee and XBee form factor wifi, bluetooth and RF modules
ON/ OFF switch to control the system power from external motor power
3 Digital I/O extensions (D14-D16)
S1 - S5 switch replace jump cap, allows free use for the GPIO.
Micro USB instead of A-B USB connector
Analog sensor extension port: Orange for Signal, Red for Vcc, Black for GND
Note:The analog sensor port pin mapping on RoMeo v2 is different from the old version. Please select Arduino Leonardo board when using Arduino IDE.
Directly support Xbee and XBee form factor wifi, bluetooth and RF modules
ON/ OFF switch to control the system power from external motor power
3 Digital I/O extensions (D14-D16)
S1 - S5 switch replace jump cap, allows free use for the GPIO.
Micro USB instead of A-B USB connector
Analog sensor extension port: Orange for Signal, Red for Vcc, Black for GND
Note:The analog sensor port pin mapping on RoMeo v2 is different from the old version. Please select Arduino Leonardo board when using Arduino IDE.
39,16 € 15,60 €
-60% Iva inclusa Disponibile
Il prodotto è disponibile presso il nostro magazzino Disponibile:Il prodotto è disponibile presso il nostro magazzino
ACQUISTI PER LA PUBBLICA AMMINISTRAZIONE?
GUIDA ALL'ACQUISTO
CAMPUSTORE RISPONDE
Descrizione
Wide operating input voltage
Directly support Xbee and XBee form factor wifi, bluetooth and RF modules
ON/ OFF switch to control the system power from external motor power
3 Digital I/O extensions (D14-D16)
S1 - S5 switch replace jump cap, allows free use for the GPIO.
Micro USB instead of A-B USB connector
Analog sensor extension port: Orange for Signal, Red for Vcc, Black for GND
Note:The analog sensor port pin mapping on RoMeo v2 is different from the old version. Please select Arduino Leonardo board when using Arduino IDE.
Directly support Xbee and XBee form factor wifi, bluetooth and RF modules
ON/ OFF switch to control the system power from external motor power
3 Digital I/O extensions (D14-D16)
S1 - S5 switch replace jump cap, allows free use for the GPIO.
Micro USB instead of A-B USB connector
Analog sensor extension port: Orange for Signal, Red for Vcc, Black for GND
Note:The analog sensor port pin mapping on RoMeo v2 is different from the old version. Please select Arduino Leonardo board when using Arduino IDE.