Contact us Acquisto Rapido

Universal Qi Wireless Receiver Module



Codice: 302284
Universal Qi Wireless Receiver Module
€ 14,90
(+ IVA 22%)

Diventa il primo a recensire il prodotto

Universal Qi Wireless Receiver Module

Muovi il mouse sull'immagine per ingrandirla dove disponibile


If you have a modern smart phone you may have noticed that it comes with built in wireless charging capability called 'Qi charging.' Qi is a trademark name for a thin and smart inductive charging system. Many large gadget companies have standardized on Qi, which means it's easy to find a charging dish and we thought it might be cool if your Arduino project can recharge itself wirelessly. Thus, we now have a Qi charging receiver module as seen here here.

This is just the inductive charging Qi receiver. It will work with any Qi charger base transmitter that will work well with any standard inductive charger base. Simply solder two wires to the V+ and Gnd pins on the Qi module and place the item you want charged onto a charging base. The receiver chip manages the coil so that you'll always get 5V and 500mA. If the coil is too far it will simply not activate at all. In our demo, we used a classic cell phone charger plate

The driver chip is an integrated receiver called the BQ51053B from TI. Since its a Qi charger it can only be used with Qi transmitters!

To demo it, we wired the module to a MiniLipo charger and a LiPo battery, as shown in the photos. Now we have a wirelessly-rechargeable battery! Note that you don't get the battery or lipo charger in your order, that's just how we're showing it off. You can even upgrade any device that takes classic USB 5V and up to 500mA. The coil comes on a metallic sticker which is used to shield the device from the coil. Make sure the coil is facing out towards the charger when you install it into your project, or it wont work at all!


Output Voltage: 4.8V - 5.2V
Current: 500mA
Operating Temperature: -40ºC ~ 40ºC

Back Panel: 48mm x 32mm x 0.5mm / 1.9" x 1.3" x 0.02"
Chip: 11.5mm x 36mm x 0.3mm / 0.5" x 1.4" x 0.01"
Copper Coil: 41mm x 29mm / 1.6" x 1.1"
Weight: 4.7g

Il CIG e il CUP sono richiesti per assicurare la tracciabiltà dei flussi finanziari nei lavori pubblici.
Art. 3 della L. 13/08/2010, n. 136 (pubblicata sulla Gazzetta Ufficiale n. 196 del 23/08/2010 - serie generale).
Gazzetta Ufficiale:

CIG = codice identificativo di gara
CUP = codice unico di progetto

N.B. Se l'ordine è composto da più articoli e si riferisce ad un unico CIG/CUP, i codici possono essere inseriti alla fine dell'operazione.

Scrivi una recensione

* Campi Obbligatori

Tag dei Prodotti

Usa gli spazi per separare i tags. Usa virgolette singole (') per le frasi.

Iscriviti alla nostra newsletter e riceverai le nostre offerte esclusive: