OctoWS2811 Adapter for Teensy 3.1 Control tons of NeoPixels!
19,76 € Iva inclusa
ADAFRUIT

OctoWS2811 Adapter for Teensy 3.1 Control tons of NeoPixels!

ADAFRUIT
OctoWS2811 Adapter for Teensy 3.1 Control tons of NeoPixels!
OctoWS2811 Adapter for Teensy 3.1 Control tons of NeoPixels!
COD: 302320
COD.MEPA: 302320CS

Descrizione

This adapter board connects the Teensy 3.1 to up to thousands of WS2811/WS2812 (a.k.a NeoPixel) LEDs using the OctoWS2811 Library.

It features a 74HCT245 buffer chip and 100 ohm series matching resistors. A CAT6 Ethernet cable is used to connect this board to the LED strips. A CAT6 cable is designed for very high bandwidth, minimal cross-talk between twisted pairs, and 100 ohm impedance, for a very high quality signal.

Teensy 3.1 is a small, breadboard-friendly development board designed by Paul Stoffregen and PJRC. Teensy 3.1 brings a low-cost 32 bit ARM Cortex-M4 platform to hobbyists, students and engineers, using an adapted version of the Arduino IDE (Teensyduino) or programming directly in C language.

This product does NOT include a Teensy, it's just the adapter!

Four self-threading screws
Eight LED outputs
Dimensions:
56mm x 34mm x 2mm / 2.2" x 1.3" x .08"
Height with Ethernet Outlets: 15mm / 0.6"
Weight: 11.1g
19,76 €
Iva inclusa
Disponibile
Il prodotto è disponibile presso il nostro magazzino Disponibile:
Il prodotto è disponibile presso il nostro magazzino

Descrizione

This adapter board connects the Teensy 3.1 to up to thousands of WS2811/WS2812 (a.k.a NeoPixel) LEDs using the OctoWS2811 Library.

It features a 74HCT245 buffer chip and 100 ohm series matching resistors. A CAT6 Ethernet cable is used to connect this board to the LED strips. A CAT6 cable is designed for very high bandwidth, minimal cross-talk between twisted pairs, and 100 ohm impedance, for a very high quality signal.

Teensy 3.1 is a small, breadboard-friendly development board designed by Paul Stoffregen and PJRC. Teensy 3.1 brings a low-cost 32 bit ARM Cortex-M4 platform to hobbyists, students and engineers, using an adapted version of the Arduino IDE (Teensyduino) or programming directly in C language.

This product does NOT include a Teensy, it's just the adapter!

Four self-threading screws
Eight LED outputs
Dimensions:
56mm x 34mm x 2mm / 2.2" x 1.3" x .08"
Height with Ethernet Outlets: 15mm / 0.6"
Weight: 11.1g

Recensioni

Hai comprato questo prodotto? Fai sapere agli altri cosa ne pensi.
Valuta