Pololu Stamped Aluminum L-Bracket for NEMA 17 Stepper Motors
6,43 € Iva inclusa
POLOLU

Pololu Stamped Aluminum L-Bracket for NEMA 17 Stepper Motors

POLOLU
Pololu Stamped Aluminum L-Bracket for NEMA 17 Stepper Motors
Pololu Stamped Aluminum L-Bracket for NEMA 17 Stepper Motors
COD: 305319
COD.MEPA: 305319CS

Descrizione

This lightweight (about 15 g) but strong bracket is made from 3mm-thick black anodized aluminum and is specifically designed to work with the typical faceplate mounting holes of NEMA 17 stepper motors. The slots through which the motor mounts to the
bracket allow for 2 mm of play for fine-tuning position, and four 6 mm M3 screws are included for securing the motor to the bracket (note: these M3 screws work with all of the NEMA 17 stepper motors we carry; different screws might be required when using this bracket with stepper motors from other suppliers). The other side of the bracket includes a variety of slots and
holes that can be used with #6, #8 and M4 screws.

This bracket makes it easy to mount and integrate NEMA 17 size motors like our stepper motor with lead screw into your project. These brackets also fit the 42×18.6mm Sanyo pancake motor and the 42×11.6mm Sanyo pancake motor, though the two Sanyo motors
have short output shafts that will only extend two millimeters past the edge of the bracket.
6,43 €
Iva inclusa
Su ordinazione
Il prodotto non è presso il nostro magazzino e i tempi di consegna dipendono dal nostro fornitore: contattaci per dei tempi di consegna più precisi Su ordinazione:
Il prodotto non è presso il nostro magazzino e i tempi di consegna dipendono dal nostro fornitore: contattaci per dei tempi di consegna più precisi

Descrizione

This lightweight (about 15 g) but strong bracket is made from 3mm-thick black anodized aluminum and is specifically designed to work with the typical faceplate mounting holes of NEMA 17 stepper motors. The slots through which the motor mounts to the
bracket allow for 2 mm of play for fine-tuning position, and four 6 mm M3 screws are included for securing the motor to the bracket (note: these M3 screws work with all of the NEMA 17 stepper motors we carry; different screws might be required when using this bracket with stepper motors from other suppliers). The other side of the bracket includes a variety of slots and
holes that can be used with #6, #8 and M4 screws.

This bracket makes it easy to mount and integrate NEMA 17 size motors like our stepper motor with lead screw into your project. These brackets also fit the 42×18.6mm Sanyo pancake motor and the 42×11.6mm Sanyo pancake motor, though the two Sanyo motors
have short output shafts that will only extend two millimeters past the edge of the bracket.

Recensioni

Hai comprato questo prodotto? Fai sapere agli altri cosa ne pensi.
Valuta